On Windows Vista (and later) SyncBackPro/SE/Lite cannot see networked drives but SyncBackFree can
This issue is due to security changes introduced with Windows Vista (and continued with later versions of Windows). Microsoft made a change in Vista such that drives that were mapped without elevated privileges cannot be seen by processes run with elevated privileges:
Instead of using a mapped drive letter in SyncBackLite/SE/Pro, you can instead use a UNC path in point to your network share. A typical UNC format will look like this:
Network credentials to allow SyncBack access to your shared folder
If your network drive requires username/password credentials for access, you may need to save them under:
Modify > Expert > Network
so that SyncBack can provide the correct credentials during Unattended backups (Scheduled runs).
How do I find my UNC path?
One way to locate the UNC path of your network share is to look at the mapped drive in Windows Explorer. A network share may look like this in Windows XP and Windows 7 respectively:
Shared_Folder_Name on 'servername' (X:)
Shared_Folder_Name (\\servername) (X:)
or it could look like this (if you browse the Network to locate your shared folder):
In the first example, the share-name is shown first, followed by the machine-name, then the drive letter. The first two parts, when reversed & formatted appropriately equate to the UNC path:
which is what you should enter in SyncBack's Source or Destination box (plus any optional subfolder path within the share, if used).
SyncBackPro/SE/Lite runs with elevated privileges (by default) in Vista-and-later because it requires the use of certain Windows functions (e.g. open/locked file copying) that are only available (in those versions of Windows) when using elevated privileges. You can configure SyncBackPro/SE/Lite to run without elevated privileges:
Other ways to locate your UNC Path
You can likely also browse (click 'folder ' button on left of Source or Destination box) directly to the UNC path if you navigate via the Network section displayed in the browse dialog. Simply navigate ('drill into') to the machine-name, then select the share-name, and if required, any subfolder path within the latter.
Note that you cannot simply enter the machine-name and have it 'back up all shares' (Windows does not permit that: network connections must be to a specific/individual share). If you browse the Network section and try to select just the machine name, SyncBack will warn you that is not allowed.